It’s the way it is mixed that matters the most. In other terminology, consistency. You fancy the mud to be thick if you are doing a plaster project or remodeling out of the mud itself. You wish it to be thinner for regular work.
Q: I have durarock in my bathtub/shower area and moisture resistant rock on the rest of the bathroom wall. How do I mud and tape the place between the two different materials? Do I required a different type of mud? I am using mesh tape for the joints. The other thing when doing bathroom is decorative cabinet hardware and bath hardware and also brass bathroom hardware
Water Rock is absolutely similar to Moisture Rock which is the Greenboard. No special mud is needed or best when using Greenboard to Durarock. Regular Sheetrock Mud is just fine. You don’t have to use any special type of mud when meshing up either.
There are two different sorts of mesh. Blue Mesh and Yellow Mesh. The Yellow Mesh is a little heavier than the Blue Mesh. The Blue Mesh is used mainly for doing inside corners. If you want to use Mesh Tape, Sheetrockers Secrets Recommends the Yellow Mesh for this sort of project as it is stickier on the back side than the Blue Mesh.
When you mix the mud for the mesh, mix it as you normally would but the mesh will take more mud as the little squares need to be filled in. This will take more drying and sanding time. After you apply the mud to the mesh, spread it down evenly with a mudding knife and get it as smooth as possible. This will help with reducing the drying and sanding time. Don’t press hard as it may cause the mesh to become distorted and you may have to use another piece and start over again.
The only thing I would do different is not use mesh tape at all, I would use regular sheetrock tape. The explanation for this is that mesh tape gives. Even after it dries and you have painted. As the house settles, the mesh tape moves more simply and it will eventually crack. This gives way to mold and insect infestations which may result for you to replace it with regular sheetrock tape later in time. This is a whole different project in and of itself.
Mesh tape would be best applied on inside corners or patch jobs as it sort of produces a fiber fortified spot. So if you have a patch job or corners, like the inside of windows, when the house settles, the surrounding area is the support and not the weak spot or corners and because mesh moves more easily, your project will last longer and ofcourse to jazz up the bath you can always use low cost bathroom hardware
Materials used:
Sheetrock Tape or Mesh Tape
Measuring Tape
Sheetrock Mud
Bathroom hardware
decorative Bathroom Hardware
Mudding Tray
Mud Knife
Sander
220 Grit Sandpaper
Damp Cloth
Cabinet Hardware
Bath Cabinet Hinges
Fetch useful knowledge in the sphere of suspended ceiling – make sure to read the site. The time has come when proper information is really within your reach, use this chance.